Beckman Coulter JS-5.3 Swing Bucket Centrifuge Rotor 5300 RPM Made in USA
For Use: Avanti J-26S XP Series, Avanti J-26 XP Series, Avanti JXN-26, and Avanti J-E Centrifuges.
The JS-5.3 is a four-place swinging-bucket rotor used in Beckman Coulter Avanti JXN-26, J-26S XP series, Avanti J-26 XP series, Avanti J-E, and discontinued J-20 XP series centrifuges. Each rotor bucket can carry a 96-well kit for high-throughput processing (such as a DNA or RNA kit), or standard microplates used in the serial dilution of small liquid volumes—up to six stacked (not to exceed 83.2 mm/3.28 in.) 96-well polypropylene plates, two (stacked) deep-well plates, or one square-well plate per bucket. An array of adapters carry a wide range of tube and bottle sizes (from 1.5 to 500 mL).
The rotor yoke is made of aluminum and is black-anodized for corrosion protection. Blue-anodized aluminum buckets can be run by placing them over pivot pins on the arms of the yoke; they swing out to horizontal position during centrifugation. A tie-down knob secures the rotor to the centrifuge drive hub. Aeroseal covers, made of transparent polyphenysulfone (PPSU) are available. These covers have been tested* to demonstrate containment of microbiological aerosols under normal conditions of the associated Beckman Coulter rotors and centrifuges when used and maintained as instructed. In the event of labware leakage, the covers will contain liquids and broken labware, reducing the need to clean the centrifuge chamber and allowing you to take appropriate precautions before removing the covers.
Each cover requires a replaceable silicone rubber O-ring that seats around the outside edge of the cover. An air-vent filter allows passage of air, but not of liquids or aerosols larger than 0.3 micron, in and out of the bucket to minimize the effects of vacuum conditions inside the centrifuge during operation. The covers are held in place by attached latches.
Condition:
- Photos represent the exact item that will be shipped. Please refer to the photos.
